fuel pump assembly out but cannot figure out how to get the fuel pump out of the plastic assembly

Question:

I am trying to replace the fuel pump in my 2000 hyundai accent. I have the fuel pump assembly out but cannot figure out how to get the fuel pump out of the plastic assembly.

Answer:

This is a complete module unit and is replaced all in one piece. You do not remove it from the plastic module.

a/c is blowing warm and my engine is overheating

my 2002 Hyundai Elantra a/c is blowing warm and my engine is overheating. The belts are all in place. there are no leaks of coolant on the ground. There are no noises coming from the water pump. Do you have any ideas what may be the problem? I ran over a deer a few weeks back on the interstate. The car has ran fine since, but I did sustain some damage around the radiator (braces got bent up). I am wondering if this problem has popped up after the fact.

Answer:
Most likely cause (since you hit a deer) would be that there is a hole in the A/C Condenser (Reference Diagram) that is located in front of the radiator. This would allow the freon to escape.

As for the overheating, since some brackets were bent, etc. there is probably some damage that was done to the fan assembly not allowing the fan to function for the radiator. This would make it overheat.

Another thing that would cause both issues would be air flow restriction. If there is deer fur stuck in the condenser and blocking air flow, neither the A/C system would work properly nor would it allow air to flow through the radiator also causing the engine to overheat.

How much transmission fluid goes in a 2005 Sonata

Question:

I have a 2005 Hyundai Sonata. I just need to know what to do to change the transmission oil and how much does it need?

Answer:

The total capacity is 8.5 qts. Simply draining the pan does not get all fluid out of system, so drain and fill capacity is usually about 3-4 qts. Remove the drain plug, drain the fluid, note amount drained out, and take care to check level frequently when filling so not to overfill.
Hyundai recommends using only Hyundai SP111 trans fluid.

I am unable to turn the immobiliser off

I have a Hyundai coupe w reg. It has a factory fitted immobiliser. I am unable to turn the immobiliser off, I can open the car with the keys, but when I try the ignition it is dead, nothing works, there are no lights when you open the door, everything is immobilized, how can I turn the immobiliser off so I can use the car, and take it to a garage.

ASNWER:

The immobiliser is integral with the cars ECU, and therefore cannot be switched off, it will need to be diagnosed and either repaired or reprogrammed using a JOBD diagnostic system, that has suitable software. Most good auto electrical engineers should have the correct equipment, and some of them also work mobile, so they may be able to get you up and running without you having to take it to them.

My 1999 Hyundai Accent won't start

1999 Hyundai Accent

My 1999 Hyundai Accent won't start. When I turn the key there is no click , the engine doesn't even try to turn over, there's just nothing. The only thing that happens is that my inside lights go on and radio etc. So i thought it was the starter so i changed it. When i tried starting it nothing happen again beside the lights going on in the car etc. So i thought it was the battery so i got a new battery and put that in. The car started once then died out. Now its back to normal. I Try to start the car and there is no click, there's just nothing besides the lights illuminating inside the car etc. what could be the problem?? Already Tried: changing battery and starter

Answer:
There could be a couple of issues. Your vehicle is equipped with a starter relay (located in the engine compartment relay panel), you can try to replace that. Sometimes there other relays on-board that you can use because they are the same as.Another concern that can't be over looked are the negative and positive battery cable condition. If there is too much resistance in the cables (corrosion) the current cannot flow to the starter. There is a test called a voltage drop test. Let me know if you are interested in performing it. If not, have a professional technician do the test.

Engine No Start Diagnostics

2010 Hyundai Genesis Coupe - Performance with Style

2010 Hyundai Genesis Coupe

GENESIS COUPE SPECIFICATIONS

• Configuration: Front engine, rear-wheel drive
• Wheelbase: 2820 mm / 111.0 inches
• Overall length: 4630 mm / 182.3 inches
• Overall width: 1865 mm / 73.4 inches
• Overall height: 1380 mm / 54.3 inches
• Wheels: 18-inch or 19-inch five-spoke
• Engine types: 3.8-liter V6 or 2.0-liter 4-cylinder turbo
• Est. horsepower V6: 306 @ 6,000 rpm (regular fuel)
• Est. horsepower V6: 310 @ 6,000 rpm (premium fuel)
• Est. torque V6: 263 lb. ft. @ 4,700 rpm (regular and premium fuel)
• Est. horsepower 2.0t: 212 @ 6,000 rpm (regular fuel)
• Est. horsepower 2.0t: 223 @ 6,000 rpm (premium fuel)
• Est. torque 2.0t: 217 lb. ft. @ 2,500 rpm (regular and premium fuel)
• Block & head materials: aluminum for both engines
• Valvetrain: DOHC for both engines
• Valve timing: continuously variable valve timing for both engines (Dual for 2.0t)
• Estimated 0-60 mph V6: under 6 seconds
• Transmission types: 6-speed manual, 5-speed automatic (4-cylinder) or 6-speed manual, 6-speed automatic (V6)
• Front brakes: 12.6-inch (standard) 13.4-inch (Brembo package)
• Rear brakes: 12.4-inch (standard) 13.0-inch (Brembo package)
• Front calipers: single piston floating (standard), monobloc four-piston (Brembo package)
• Rear calipers: single piston floating (standard) monobloc four-piston (Brembo package)
• Limited slip differential (Optional)
• Est. top speed: 149 mph (V6), 137 mph (2.0t)
• Base curb weight: 3549 lbs. (V6); 3439 lbs. (4-cylinder)